TOWER CASE MODDING !

INWIN Q500 tower casing modding ....

original look on INWIN Q500

equipment that will be install inside the tower casing

Removing all the panel & device rack 1 by 1 for the painting session

Changing the molex connector & sleeving ... if u dont have the right tool to remove the pin of the connector it will be a pain in the ass !!!@@$$%^&*

for your own benefit just take a simple photo before removing the molex connector

the painting session ... i spray the casing with 3 layer of flat black and 1 layer of clear spray ... before the session begin i allready remove all the rivet at the casing to get the casing part by part so i wont miss anything while spraying ... after spraying i have to reassamble the casing and rivet it back together ;))

like i said after the painting session i have to reassamble back the casing and rivet the tray all back together like they allways does xD ...

The painting session is done ... now we have to cut the top panel to fit 120mm cooler master fan (2) it will be 240mm x 120mm for the 2 fans ... before that i show u the tools that i use for cutting ...

Cutting the top panel ...

Cutting the left panel


Result of top panel and left panel

Reinstall hardware after cable management
( no more messy wire .. but pls ignore the On/Off wire that lay at the bottom )
Cover the Top panel with carbon fiber sticker



Try to get the true look of the top panel on the casing ;p


it still have alot of touch up to finish this but i cant wait to test the light ...
the glow in the dark connector not response accordingly due to not enough UV LIGHT !!!
the uv light come in set of 2 ... but 1 of the light spoil badly enuff i didnt keep the receipt to change the light back !!! !!@!@##!@#$%^

lets try it in the dark :P ngeeee

i move the up light to the upper deck so u can get the idea of glow in the dark molex connector